See the imer 10 foot slab saw combi 3000 marble and granite fabrication saw in action. High Performance that’s affordable and portable!! The 4 hp, 220v single phase motor uses a belt drive to allow the blade to have the power to cut all types of materials. The drive system uses a separate 1/2 hp motor and runs the cutting head with a solid gear and track drive. The result is fast and accurate chip free cuts are automatically made pass after pass. The saw beam hydraulically tilts to 45 degrees for perfect miter cuts, makes seamless counter top backsplash. The Combi 3000 marble and granite slab saw for fabrication is easy to set up, simple to operate, yet just as accurate and fast cutting as the most complicated stationary bridge saw. Cut 10′ slabs of granite and marble in just a minute and a half with accuracy to 1/32″. The saw is fully automated and the controls are very user friendly so new operators can be trained and be cutting in just an hour or two. The Combi 3000 is extremely sturdy. and designed to be portable. You can use the forklift or hoist points to move it around the shop, or load it to the jobsite.
14″ blade 1″ arbor
Hydrolic tilting head to 45 degree
Water collection tub
Side table
Eltronical driven
Electronic control panel
Fork lift holes built in
10′ cutting length
Joy stick controls
Off the truck ready to run, Plunge cuttin head, Side table, Additional side table available
Duration : 0:3:26
[youtube P_sXQBhtdcQ]